First Endeavor Paintball (FEP) 06 / OG / 07 / Critical Quest

[THE JEW (RaVeN)]

How to do the LPR & HPR vent hole mod without drilling into the side of the reg.

[THE JEW (RaVeN)]

Flip the trigger around, file it a bit, and an Ion trigger will work in a Quest:

http://www.pbnation.com/showthread.php?t=3344198

[THE JEW (RaVeN)]

I did the LPR purge hole with a 1/16 bit and a drill... I can say that this is a MUCH needed mod. My pressure was dropping pretty bad in PSP, but since the mod the LP drops may 10 psi.Great job on this one juit.

I also did the macroline (tape) mod, but need to get to a chrono to test.

One thing that I did since the stock bolt had some pretty bad wear on the tip is polish the very front. I also added an oring on there as a front bumper. Overall I am VERY pleased with the results.
__________________

http://www.pbnation.com/showthread.php? ... st77467248

[THE JEW (RaVeN)]

Quego (ie. Quest + Ego)
http://www.pbnation.com/showthread.php?t=3440693

UL Framed Quest
http://www.pbnation.com/showthread.php? ... highlight=

[THE JEW (RaVeN)]

Back bumper mod.

found some square orings with the size of the back bumper

I made some grooves so the air to prevent the bolt stick with the bumper

it shot like butta with rebals

tomorrow Ill do a field test with the gray quest







OK the best bumper Ive got for stock snatch pin is the timmy V front ram sleeve oring, This has the lowest no bolt stick