Hoppers / Loaders / Shake 'n Bakes / Tubes

[THE JEW (RaVeN)]

Empire Prophecy ultimate thread:

http://www.pbnation.com/showthread.php?t=2997876

[THE JEW (RaVeN)]

Max voltage to a stock Halo:

10.8 has blown out halo/reloader boards before so I wouldn't go above 9.6

http://www.pbnation.com/showthread.php? ... ight=magna

[THE JEW (RaVeN)]

The stock Magna cone is the same as the S4 upgraded version:

Originally Posted by AbitNutz
Is the Magna drive cone shaped like the S4? The S4 has fillets at the root of paddles that cradle the paintball. I can't tell form the pictures if the Magna has the same desgn.

Yes it does.

http://www.pbnation.com/showthread.php? ... st41289089

[THE JEW (RaVeN)]

Magna and Cheetah board combo:

when I used it with my Cheetah it can slip but before it does it clears the jam, I had to use mine in purple mode, blue/yellow it didn't work as well. But with the Magna it cuts down on jamming A LOT.

http://www.pbnation.com/showthread.php? ... st42132653

Originally Posted by Oedipus
Any idea why my cone seems to be hopping out of the spring cup whenever the anti-jam of the Cheetah kicks in (or if I put more than two pods through it without an unjam)? It only does this when I'm not using the magnetic part of the kit, so I'm using the spring cup without the star-shaped adornments. It's very frustrating because it releases the spring tension.

so you're just not using magnets or are you using the direct drive. The kit comes with 2 cups 1 for magnets and 1 for no plate, magnet and magnet holder. That 2ed one is the one you need.

http://www.pbnation.com/showthread.php? ... st43753479

It seems to be ok, reballs just jam and jam and jam very badly, for the reason you stated when the Cheetah does it's auto unjam, the clutch slips. I'm still messing with the pattern/plates for the clutch.
I have it at either 3 inside and 3 outside or 4 inside, 3 outside with the star plate, and the soft spring and it feeds paint flawlessly, I tried all magnets with the hard spring and the star plate with reballs, it didn't work too well.
It's a trial and error with the patterns/plates/spring from what I found.
3 inside 3 outside / N plate / soft spring is what I ran last weekend and it was butter all day, worked perfect on PSP ramping.

http://www.pbnation.com/showthread.php? ... st45981354


How the magnet / spring combo works:

the outer ring determines how much pressure is on the stack before it slips

the inner ring determines how much constant pressure is on the stack even while slipping

The plates go from softest to hardest
I plate
diamond
triangle
N
Star

There is also a Hard and Soft spring that determines the stack pressure during full wrap and is what causes the plates to slip when the spring pressure is more then what the magnet can hold in place.

That is a VERY good question I am going to add it to my first page!

http://www.pbnation.com/showthread.php? ... st43769747

[THE JEW (RaVeN)]

XeonPB's Smart Guide "cone" for Halo's:

http://www.pbnation.com/showthread.php? ... highlight=

Looks like a spinning freeway with clutch technology. Pretty cool.

[THE JEW (RaVeN)]

Simon explains how the Prophecy (and later version Magnas and B2's) slow down the motor when they detect you're almost empty:

http://www.mcarterbrown.com/forums/pain ... ost1999051

[THE JEW (RaVeN)]

HOW TO: 45-degree stick feed for open-class guns
http://www.mcarterbrown.com/forums/diy- ... -guns.html

[THE JEW (RaVeN)]

VL Quantum mods:

Polarity reverse:
http://www.youtube.com/watch?v=BNuB-IgUPLg

Triple spoon:
http://www.youtube.com/watch?v=2gL0MqIVfNk

[THE JEW (RaVeN)]

Coat the inside of your 12'vy holders with silicone to make sure you don't lose them:

http://www.mcarterbrown.com/forums/diy- ... ement.html

[THE JEW (RaVeN)]

Very cool loader shell:

http://www.versagear.com/Versa_Shell_Assembly.html

Have more than one manufactures loader? Versa Shell™ has you covered...

The unique Versa Shell™ fits five of the leading paintball loaders.
Halo Reloader B Vlocity Vlocity Jr. Magna Loader

[THE JEW (RaVeN)]

How the Pulse line was killed:

http://www.nationalpaintball.com/html/pr_020907.asp

[THE JEW (RaVeN)]

Bilge hose:

http://www.ponds2go.com/ProductDetails. ... de=P034U-F

Cheap alternative for your Warp feed.

[THE JEW (RaVeN)]

KEE has re-released the Revvy:

http://www.paintballgateway.com/vlvire12vopa.html

[THE JEW (RaVeN)]

Dye Rotor durability test:

http://www.youtube.com/watch?v=XdqKg0PI ... gest-vrecs

[THE JEW (RaVeN)]

Uncapped Prophecy with an Ion tops out at 36bps:
https://www.youtube.com/watch?v=KcvlxtiABnA

The inconsistencies in the reg means that some of the rounds collide with each mid-air.