Page 1 of 1
Where do you dremel?
Posted: Sat Mar 06, 2004 3:46 pm
by Dempsey
It makes a huge mess. Where do you guys recommend that I dremel. Consider that i dont have a garage or basement. Also does it normally go through cutting disks like they're going out of style? Holy crap they wear down fast.
Posted: Sat Mar 06, 2004 6:12 pm
by [PX]Kal Bob
outside, on the porch perhaps. And yes they do go fast, that is why I switched to a Die Grinder.
Posted: Sun Mar 07, 2004 3:48 am
by THE JEW (RaVeN)
I also just use the reinforced disks (20 per tube) cuz I find it get more cutting "power" outta them rather than the 5 pack. Don't push into the metal too hard; let the disc do the cutting. Also, always wear safety goggles or you'll end up with my Dad holding a giant fridge magnet over your eye trying to get out a shattered piece just before New Year's Eve.
Posted: Sun Mar 07, 2004 7:03 pm
by [PX]IronFist
Didn't you end up going to the hospital anyway?
Posted: Sun Mar 07, 2004 11:28 pm
by THE JEW (RaVeN)
Yup. Tillsonburg ER was helpful as always.
Posted: Mon Mar 08, 2004 12:07 am
by Dempsey
Ok cool. I have three pairs of safety goggles from work so im covered. I let you know how the cutting goes.